Waste water disposal units - San.iQ cut V

Sewage lifting units with Barracuda cutting system for WC-direct connection

50 Hz


Discharge size
Ø 40/32 mm

Max. head
6.5 m

Max. flow
6.5 m³/h

Motor power P1
0.65 kW

Motor power P2
0.35 kW

Instruction Manual





Waste water disposal units - San.iQ cut V


Small lifting unit for the pre-wall installation. Disposes of shower, washbasin, urinal, bidet, WC in rooms below the backflow level of the sewer (basement or cellar rooms), or without sufficient gradient to the next sewer collection pipe. For the disposal of sanitary units in accordance with DIN EN 12050-3, San.iQ cut V is the ideal, cost-effective problem solution.


Collection container (plastic (ABS)) Pump housing (glass fibre reinforced plastic) Impeller (glass fibre reinforced plastic) Motor housing (stainless steel 1.4301) Motor shaft (stainless steel 1.4021) Cutter (stainless steel 1.4122)

Pumped liquid

Dirty water and faeces. Max. Temperature of the pumped medium: 35°C, briefly up to 60°C.


Single phase electric motor. Thermal sensor for temperature monitoring in the winding. Insulation class B. Stainless steel motor shaft, permanently lubricated roller bearings.

Collection Tank

Non-rotting, gas-tight and odourless plastic container with separate drying area. Volume 11 litres. WC inlet DN 100 horizontal, inlet height 180 mm (DIN 1387 form A / DIN 1388 form A). Two lateral inlets DN 40 with integrated non-return valve, wedge seal ring and pressure ring. Pressure connection Da 28-34 with integrated ball check valve. Ventilation opening with activated carbon filter.


San.iQ cut V was developed especially for pre-wall installation. All important components of the system are easily accessible through the inspection opening. The container ventilation with activated carbon filter is located directly next to the motor unit, to which a ventilation pipe can also be connected in order to exclude moisture problems within the pre-wall. In case of maintenance, the venting unit can also be removed in order to pump the container empty with the help of a wet vacuum cleaner.


Impeller of the San.iQ cut V series.

For optimum adaptation to the pump medium and operating conditions.

GRP cutter system

Cutting system upstream of the impeller for grinding solids.

Open multi-channel impeller

For dirty and muddy media with solids.

The network frequency is 50 Hz in the EU.
In other parts of the world, such as in the North American region, Brazil, Saudi Arabia or South Korea 60 Hz.

HOMA pumps are available for both frequency ranges. A selection of the pumps for the valid frequency range at the installation site must be made accordingly. We are happy to assist you in the selection of the right pumps.

Select 50 Hz

Select 60 Hz

At this point, you exit the HOMA website and are directed to the website offering our pump selection software HOP.Sel.


50 Hz