Sewage pumps with cutter system - TGR15

Submersible pumps with cutter system for sewage and effluent

50 Hz

Specifications:

Discharge size
G2

Max. head
24,0 - 26,0 m

Max. flow
10,5 - 11,0 m³/h

Motor power P1
1,5 kW

Motor power P2
1,2 kW

Characteristics

Sewage pumps with cutter system - TGR15

Application

The installation of conventional sewer systems in areas of low population like small villages, farms or under difficult topographic conditions is often extremely expensive, mainly because of the high cost for large diameter pipework installation. The TGRs cut all solids present in the sewage into small particles. This allows the use of pipes from 1 1/2“ diameter, which can be easily laid at low cost with a minimum of construction work.

Installation

Transportable or permanent. Models with float switch control for automatic pump operation, depending on liquid level in the sump.

Materials

Pump housing (Cast iron EN-GJL-250) Cutter system (Stainless steel) Impeller (Stainless steel 1.4308) Motor housing (Stainless steel 1.4301) Rotor shaft (Stainless steel 1.4104) Motor housing cover (Composite GFK30) Mechanical seal (SiC) Mechanical connection parts (Stainless steel) Elastomere (NBR)

Pumped liquid

Clear water and drainage water, sewage containing soft solids. Max. liquid temperature: 40°C.

Motor

Fully submersible, pressure tight electric motor, single or three phase. Thermal sensors embedded in stator winding. Insulation class F, degree of protection IP 68.

The network frequency is 50 Hz in the EU.
In other parts of the world, such as in the North American region, Brazil, Saudi Arabia or South Korea 60 Hz.

HOMA pumps are available for both frequency ranges. A selection of the pumps for the valid frequency range at the installation site must be made accordingly. We are happy to assist you in the selection of the right pumps.


Select 50 Hz

Select 60 Hz

At this point, you exit the HOMA website and are directed to the website offering our pump selection software HOP.Sel.

Frequency

50 Hz