8 - 10 mm
G2 1/2 / B-Festkupplung
16,0 - 23,5 m
50,4 - 75,6 m³/h
Motor power P1
1,8 - 3,5 kW
Motor power P2
1,4 - 2,8 kW
Fire pumps of types of FW-TP 4 / 1 and FW-TP 8/1 are mainly used for flooding and in case of disaster. They pump clean or dirty water, also with abrasive sand and solids up to 8 mm (FW-TP 4/1) or 10 mm (FW-TP 8/1).
Motorhousing, Suction strainer (Sea water resistant aluminium casting) Pump housing, Impeller (Grey cast iron GG25) Suction sieve, Screws, Nuts (Stainless steel 1.4301) Motor Jacket FW-TP 4/1: (PVC) FW-TP 8/1: (Stainless steel) Motor shaft (Stainless steel 1.4104) Mechanical seal on medium side (SiC/SiC) Elastomere (NBR).
Clear or drainage water with abrasive solids (eg. sand). Max. liquid temperature: 40°C, short term up to 60°C.
Fully submersible, pressure tight electric motor, oil filled. Insulation class H. Degree of protection IP 68. Cable Connection chamber totally isolated from motor housing.
The low construction width and the overhead discharge enable use in narrow shafts. The jacket cooling of the motor through the pumped liquid protects against overheating also in snore mode at extremely low water. The pumps are tested according to DIN14425 and suitable for the initial equipment of vehicles of the fire service and technical support services.
For optimum adaptation to the pump medium and operating conditions.
For dirty and muddy media with solids.
The network frequency is 50 Hz in the EU.
In other parts of the world, such as in the North American region, Brazil, Saudi Arabia or South Korea 60 Hz.
HOMA pumps are available for both frequency ranges. A selection of the pumps for the valid frequency range at the installation site must be made accordingly. We are happy to assist you in the selection of the right pumps.
At this point, you exit the HOMA website and are directed to the website offering our pump selection software HOP.Sel.